Roof Opening Panel Motor Initialization

For an existing roof opening panel motor skip to step 3.

Roof opening panel motor initialization.

If the slide switch is released before initialization movements are complete turn the ignition key to the off position then back to the run position and repeat this step. Refer to workshop manual section 501 17. Quickly release and re press and hold the slide switch. For a new roof opening panel motor.

For a new roof opening panel motor proceed to step 2. The roof opening panel will cycle slightly rearward and then slightly forward to the stored open position. The roof opening panel motor initialization procedure must be done when repairs are carried out on part of the roof opening panel system including. A new roof opening sliding glass or power shade motor has been installed.

Any time the roof opening panel motor has been removed from the roof opening panel assembly a new roof opening panel motor has been installed or when a new roof opening panel assembly has been installed. Turn the ignition to the run position. Assembly a new roof opening panel motor has been installed or when a new roof opening panel assembly has been installed. The roof opening panel does not open or close properly note.

The initialization movements will start within approximately 3 seconds after the switch is pressed. The roof opening panel assembly has been removed from the vehicle. Initialize reset or reprogram a 2015 18 f 150 s 350 s vista sunroof note. If your sunroof is broken or making a popping snapping noise this won t f.

The roof opening panel glass will move to the full vent position then back to closed initialization movements.